help with port forwarding

from Demigod Forums

I know that I'm suposed to open ports 6100-6200, but I'm not exactly sure what information to enter where on the port forwarding page . I've looked at the pages on portforwarding.com, but mine looks different then those.

 

it looks like this http://s297.photobucket.com/albums/mm216/tenkuchima/?action=view&current=portforward.jpg

 

I just need to know what to enter in which boxes, all help is greatly apreciated.

18,077 views 3 replies
Reply #1 from Demigod Forums Top

Im not sure i only have experience changing netgear and lynksys routers.

There should be 3 boxes: First one for the starting range (6000), Second box for the ending range (6200) and a third box for your ip adress (192.168.1.102)

to figure out your ip address go to start-run- type (cmd)- then type (ipconifg) it should be one of the first numbers aka 192.168.1.102 or 192.168.1.70 something like that.

Hope that helps

 

+1 Loading…
Reply #2 from Demigod Forums Top

From looking at your image, it looks as if your device is forwarding your ports to an IP automatically - I couldn't see a section where to enter your IP Address. Not sure if this is going to be a problem or not, but try it and see what happens.

In the "Source Ports" fields enter '6000' in the first box and '6200' in the second, and the same again in the "Destination Ports". This should open all the needed ports for Demigod.

Also, in your Demigod install folder on your harddrive, for example mine is C:\Program Files\Demigod, go to the 'Bin' folder and run the ImpulseReactorOptions.exe file. Specify the same ports - I believe Impulse reactor will only let you use 6002 - 6200 - to ensure Impulse is using the right ports when connecting.

Best of luck!

+1 Loading…
TouchTasks - Access tasks with ease on Windows touchscreens.
Reply #3 from Demigod Forums Top

thanks, that helps a lot